Image
MCQ
1722. Which of the following statements pertains to resistors only?
Can dissipate considerable amount of power
Can act as energy storage devices
Connecting them in parallel increases the total value
Oppose sudden changes in voltage
1724. An air-core choke coil and an electric bulb are connected in series with ac mains. On introducing soft iron bar in the coil, the intensity of light will-
fluctuate
remain unchanged
increase
decrease
1725. How long does it take 50 µC of charge to pass a point in a circuit if the current flow is 15 mA?
3.33 x 10^3s
6 x 10^3s
6.33 × 10^3s
2s
1726. In an AC circuit, a low value of KVAR compared with kW indicates-
Low efficiency
High-power factor
Unity power factor
Maximum load current
1727. In a highly capacitive circuit, the-
Apparent power is equal to the actual power
Reactive power is more than the apparent power
Reactive power is more than the actual power
Actual power is more than its reactive power
1728. Magnitude of current at resonance in R-L-C circuit-
Depends upon the magnitude of R
Depends upon the magnitude of L
Depends upon the magnitude of C
Depends upon the magnitude of R, L and C
1730. Capacitive reactance is more, when-
Capacitance is less and frequency of supply is less
Capacitance is less and frequency of supply is more
Capacitance is more and frequency of supply is less
Capacitance is more and frequency of supply is more
1731. Pure inductive circuit takes power from the A.C. line, when-
Applied voltage decreases but current increases
Applied voltage increases but current decreases
Both applied voltage and current increase
Both applied voltage and current decrease
1737. What will be the phase angle between two alternating waves of equal frequency, when one wave attains maximum value and the other is at zero value?
45°
90°
180°
30°
1738. In any A.C. circuit always-
Apparent power is more than actual power
Reactive power is more than apparent power
Actual power is more than reactive power
Reactive power is more than actual power
1739. Pure inductive circuit-
Consumes some power on average
Does not take power at all from a line
Takes power from the line during some parts of the cycle and then returns back to it during
other parts of the cycle None of the above