MCQ
401. Which of the following types of sleepers is preferred on joints?
CST-9 sleeper
Steel trough sleeper
Wooden sleeper
Concrete sleeper
402. Due to battering action of wheels over the end of the rails, the rails get bent down and are deflected at ends. These rails are called--
Roaring rails
Hogged rails
Corrugated rails
Buckled rails
403. সাধারণত কংক্রিটের কাঠামোর শতকরা কত ভাগ পূরক পদার্থ দ্বারা পূরণ করা হয়?
৬০-৬৫ভাগ
৭০-৭৫ ভাগ
৮০-৮৫ ভাগ
৯০-৯৫ ভাগ
404. Coefficient of curvature -
D30^2/ D20xD10
D10^2/ 060×D30
D20/D60×D20
D30^2/ D60×D10
Civil MCQ
জিওটেকনিক্যাল ইঞ্জিনিয়ারিং
Civil Department all mcq
সরকারি চাকুরির বিগত সালের সকল প্রশ্ন
geotechnical engineering mcq
ব্যাখ্যা: D10= Particle Diameter যার 10% কণা সূক্ষ্ম, 90% PDParticle Diameter বা কণার আকার, যার 30% কণা সূক্ষ্ম। D 30= কণার আকার যার 60% কণা সন্ধ।
উত্তর সহ কয়েকটি অনুরুপ গুরুত্বপূর্ণ প্রশ্ন
1. Coefficient of curvature D 30^2/(D10 *D60)
2. Soil এর কথার আকৃতি প্রকাশ করে কোনটি- coefficient of curvature.
3. Particle size distribution curve এর ডানদিকে কোন কণার curve থাকে- coarse grained soil.
4. Coefficient of uniformity is – D 60/D 10
405. Flange-way clearance is the distance--
Between the adjoining faces of the running rail and the check rail near the crossing
Between the gauge faces of the stock rail and the tongue rail
Through which the tongue rail moves laterally at the toe of the switch
None of the above
406. The purpose of providing fillet in a rail section is to--
Increase the lateral strength
Increase the vertical stiffness
Avoid the stress concentration
Reduce the wear
407. Pick up the incorrect statement from the following-
Sleepers hold the rails at proper gauge on straights
Sleepers provide stability to the permanent way
Sleepers act as an elastic cushion between rails and ballast
None of these
408. Liquid limit নির্ণয়ে কোনটি ব্যবহৃত হয়?
Pyconmeter
Vicat Apparatus
Casagraande apparatus
Proctor apparatus
Civil MCQ
জিওটেকনিক্যাল ইঞ্জিনিয়ারিং
Civil Department all mcq
সরকারি চাকুরির বিগত সালের সকল প্রশ্ন
geotechnical engineering mcq
ব্যাখ্যা: উত্তর সহ কয়েকটি অনুরূপ গুরুত্বপূর্ণ প্রশ্ন
1. Liquid Limit নির্ণয়ে কোনটি ব্যবহৃত হয় Casagrande apparatus.
2. If the material of the base of the Casagrande liquid limit device on which the cup containing soil paste drops is softer than the standard hard rubber, then
3. The liquid limit of soil always increases
4. Liquid limit নির্ণয়ে ব্যবহৃত হয় Cone penetration method.
5. Casagrande apparatus এ কত আঘাতে তারল্য সীমা নির্ণয় করা হয়- 25.
6. সর্বাধিক যে পরিমাণ পানি মাত্রায় কোন মৃত্তিকা প্লাস্টিক অবস্থা হতে তরল অবস্থায় যাওয়ার প্রবণতা দেখায়, তাকে কী বলে - তারল্য সীমা।
409. The main function of a fish plate is--
To join the two rails together
To join rails with the sleeper
To allow rail to expand and contract freely
None of the above
410. The type of spike used for fixing chairs of bull headed rails to wooden sleepers is--
Dog spike
Rail screw
Elastic spike
Round spike
411. Void ration (e) এবং Porosity (n) এর সম্পর্ক কিরূপ?
n= 1 +e/1-e
n = 1+n/1-n
n = e/1 – e
n = n/1-n
Civil MCQ
জিওটেকনিক্যাল ইঞ্জিনিয়ারিং
Civil Department all mcq
সরকারি চাকুরির বিগত সালের সকল প্রশ্ন
geotechnical engineering mcq
ব্যাখ্যা: এখানে, e = Void ratio এবং n porosity
উত্তর সহ কয়েকটি অনুরুপ গুরুত্বপূর্ণ প্রশ্ন
1. Void ratio (e) এবং porosity (n) এর সম্পর্ক কিরূপ-
n = n/1-n
2. What is the volume of voids in the 3 phas diagram of soil-volume of water and air.
3. what is the ratio of volume of voids and volume of soil solids - void ratio
4. what is the most common method used for the removal of veids in soil-compaction.
412. Flat mild steel bearing plates are used--
For points and crossings in the lead portion
With wooden sleepers at locations where creep is likely to be developed
On all joints and curves
all the above
413. Composite sleeper index is the index of--
Hardness and strength
Strength and toughness
Toughness and wear resistance
Wear resistance and hardness
414. Total effective bearing area of both the bowls of a pot sleeper, is-
Slightly more than that of a wooden sleeper
Slightly less than that of a wooden sleeper
Equal to that of a wooden sleeper
None of these
415. Angle of internal friction 30° হলে coefficient of active earth pressure ?
3
1/3
1
1/2
Civil MCQ
জিওটেকনিক্যাল ইঞ্জিনিয়ারিং
Civil Department all mcq
সরকারি চাকুরির বিগত সালের সকল প্রশ্ন
geotechnical engineering mcq
ব্যাখ্যা: Active earth pressure = 1-sin30°/1-sin30° = 1/2
উত্তর সহ কয়েকটি অনুরুপ গুরুত্বপূর্ণ প্রশ্ন
1. Angle of internal friction 30° হলে coefficient of active earth pressure = 1/3.
2. যে অনুভূমিক চাপের প্রভাবে ঠেস কাঠামোর ভরাটকৃত সামগ্রীর সংনমন ঘটে, তাকে কী বলে - পরোক্ষ চাপ।
3. স্বাভাবিকভাবে স্তুপকৃত মাটির পার্শ্বতল অনুভূমিকের সাথে যে কোণ উৎপন্ন করে তাকে বলে - স্থিরতা কোণ।
4. যে অনুভূমিক চাপের প্রভাবে ঠেস কাঠামোর ভরাটকৃত সামগ্রীর বিস্তৃতি ঘটে, তাকে কী বলে - প্রত্যক্ষ চাপ।
416. Effective size কোনটি ?
D 10
D 30
D 60
D 90
Civil MCQ
জিওটেকনিক্যাল ইঞ্জিনিয়ারিং
Civil Department all mcq
সরকারি চাকুরির বিগত সালের সকল প্রশ্ন
geotechnical engineering mcq
ব্যাখ্যা: 10% বৃদ্ধ কণ্যর আকারকে effective size বা কার্যকরী আকার বলে।
উত্তর সহ কয়েকটি অনুরূপ গুরুত্বপূর্ণ প্রশ্ন
1. Effective size কোনটি D10.
2. কণার আকারের সীমার পরিমাণ নির্দেশ করে কোনটি- সমভাল সহগ।
3. কণার আকারের বিতরণ রেখার আকৃতি কোনটি দ্বারা প্রকাশ করা হয় - বক্রতার সহগ।
4. সুবিন্যস্ত মাটির জন্য বক্রতার সহগ কত 1 to 3.
417. Creep is the--
Longitudinal movement of rail
Lateral movement of rail
Vertical movement of rail
Difference in level of two rails
418. Staggered joints are generally provided--
On curves
On straight track
When two different rail sections are required to be joined
None of the above
419. Clay soil-t particle size silt-এর চেয়ে-
বড়
ছোট
সমান
কোনোটিই নয়
Civil MCQ
জিওটেকনিক্যাল ইঞ্জিনিয়ারিং
Civil Department all mcq
সরকারি চাকুরির বিগত সালের সকল প্রশ্ন
geotechnical engineering mcq
ব্যাখ্যা: সবচেয়ে বড় particle size gravel
উত্তর সহ কয়েকটি অনুরুপ গুরুত্বপূর্ণ প্রশ্ন
1. Clay soil if particle size silt এর চেয়ে ছোট।
2. Silt wit size range - 0.002 mm to 0.06 mm.
3. Clay size range - 0,002 mm .ক্যান্টনমেন্ট অরিদপ্তর ৩০.১০.২০২১
4. Sand 43 size range - 0.075 mm to 4.75 mm.
5. Gravel এর size range 4.75 mm to 30 mm.
420. Two important constituents in the composition of steel used for rail are--
Carbon and silicon
Manganese and phosphorous
Carbon and manganese
Carbon and Sulphur