ফাউন্ডেশন ইঞ্জিনিয়ারিং MCQ
সিভিল ইঞ্জিনিয়ারিং এর ফাউন্ডেশন ইঞ্জিনিয়ারিং সাবজেক্টের সকল MCQ প্রশ্ন এই ফোল্ডারে পাবেন। Civil Engineering এর চাকরি প্রস্তুতির জন্য ডিপার্টমেন্ট ও নন-ডিপার্টমেন্টের সকল MCQ এর প্রশ্ন উত্তর ব্যাখ্যাসহ এখানে পাবেন। সহকারী/উপ-সহকারী প্রকৌশলী চাকরি প্রস্তুতির জন্য আমাদের App: Engineering Classroom গুগল প্লে-স্টোর থেকে ডাউনলোড করে নিন। Foundation Engineering all MCQ, Civil Engineering MCQ
21. For general engineering purposes, soils are classified by
Particle size classification system
Textural classification system
High Way Research Board (HRB), classification system
Unified soil classification system
22. Pick up the correct statement from the following:
An unconfined compression test is a special case of triaxial compression test
An unconfined compression test is a special case of direct shear test
The confining pressure is maximum during an unconfined compression test
The cylindrical specimen of a soil is subjected to major principal stress till it fails due to shearing along the plane of the failure
23. Which of the following statements is correct?
Uniformity coefficient represents the shape of the particle size distribution curve.
For a well graded soil, both uniformity coefficient and coefficient of curvature are nearly unity.
A soil is said to be well graded if it has most of the particles of about the same size
None of the above
24. Select the correct range of density index, ID
ID > 0
ID < 0
0 < ID < 1
0 < ID < 1
25. Which of the following methods is most accurate for the determination of the water content of soil?
Oven drying method
Sand bath method
Calcium carbide method
Pycnometer method
26. 'Talus' is the soil transported by
Wind
Water
Glacier
Gravitational force
27. On wetting, cohesive soils,
Loose permeability
Gain shear strength
Loose elasticity
Decrease their shear strength
28. Water content of soil can
Never be greater than 100%
Take values only from 0% to 100%
Be less than 0%
Be greater than 100%
29. The earth pressure of a soil at rest, is proportional to (where is the angle of internal friction of the soil)
tan (45°-)
tan (45°+)
tan2 (45°-)
None of these
30. A soil sample of mass specific gravity 1.92 has moisture content 30%. If the specific gravity of solids is 2.75, the void ratio, is
0.858
0.860
0.862
0.864
31. If the specific gravity and voids in soil sample are G and e respectively, the hydraulic gradient i, is
(G-1)/(1+e)
(G+1)/(1-e)
(1-G)/(1+e)
(1+G)/(1+e)
32. Pick up the correct statement from the following:
Failure plane carries maximum shear stress
Failure plane does not carry maximum shear stress
Failure plane carries shear stress equal to maximum shear stress
None of these
33. In a flow net
Flow lines and equipotential lines cross each other at right angles
Fields are rectangles whose length is twice the breadth
Smaller the dimensions of the field, smaller will be the hydraulic gradient and velocity of flow through it
For homogeneous soil, the curves are smooth and circular
34. The reduction in volume of soil due to squeezing out of water from the voids, is termed
Primary consolidation
Primary compression
Primary time effect
All the above
35. A soil sample of mass specific gravity 1.92 has moisture content 30%. If the specific gravity of solids is 2.75, the degree of saturation, is
95.4%
95.5%
95.6%
95.7%
36. If the voids of a soil mass are full of air only, the soil is termed as
Air entrained soil
Partially saturated soil
Dry soil
Dehydrated soil
37. Pick up the correct statement from the following:
The void space between the soil grains, is filled partly with air and partly with water
In perfectly saturated soil, the voids are completely filled with water
In dry soil, the voids are completely filled with air
All the above
38. Pick up the correct statement from the following:
Sandy clayloam contains highest percentage of sand
Silty clayloam contains highest percentage of silt
Stiff boulder clay offers maximum shear strength
Soft chalk carries least safe load
39. Through a point in a loaded soil mass, there exists typical planes mutually orthogonal on which the stress is wholly normal and no shear stress acts, if is
1
2
3
4
40. The phreatic line in an earth dam may be
Circular
Elliptical
Parabolic
A straight line