MCQ
1641. A material is said to be perfectly elastic if--
It regains its original shape on removal of the load
It regains its original shape partially on removal of the load
It does not regain its original shape at all
None of these
1642. The clay mineral with the largest swelling and shrinkage characteristics is
Kaolinite
Illite
Montmorillonite
None of the above
1643. IF Q is load factor, S is shape factor and F is factor of safety in elastic design, the following:
Q=S+F
Q=S-F
Q=F-S
Q=S*F
1644. The seepage exit gradient in a soil is the ratio of
Total head to the length of seepage
Flow line to slope
Head upstream to that at downstream
Head loss to the length of the seepage
1645. Chemical weathering of soil is caused due to
Oxidation
Carbonation
Hydration
All the above
1646. The length/diameter ratio of cylindrical specimens used in triaxial test, is generally
1
1.5
2
2.5
1647. Which of the following methods is more suitable for the determination of permeability of clayey soil?
Constant head method
Falling head method
Horizontal permeability test
None of the above
1648. A shaft rotating N.R.M. under a torque T, transmits a power--
/30 Newton metres/sec
/30 Newton metres/min
/60 Newton metres/min
/60 Newton metres/sec
1649. Pick up the correct statement from the following:
Isotropic consolidation of clay can be obtained in the triaxial apparatus under equal allround pressure
If the present effective stress is the maximum to which the clay has ever been subjected, it is called normally consolidated clay
If the present effective stress in the past was more than present effective stress, it is called over-consolidated clay
All the above
1650. If the bulk density of the soil is and water content, then dry density of the soil, is
1+/
(1+)/
/(1+)
/(1+)
1651. Compression of soil occurs rapidly if voids are filled with
Air
Water
Partly with air and partly with water
None of these
1652. The maximum load carried by a pile, when it continues to sink without further increase of load, is known as
Ultimate load carrying capacity
Ultimate bearing capacity
Ultimate bearing resistant
All the above
1653. Select the correct statement.
Coefficient of compressibility of an over- consolidated clay is less than that of a normally consolidated clay
Coefficient of compressibility of an over- consolidated clay is greater than that of a normally consolidated clay
Coefficient of compressibility is constant for any clay
None of the above
1654. If the shearing stress is zero on two planes, then the angle between the two planes is
45"
90°
135°
225"
1655. For better strength and stability, the fine grained soils and coarse grained soils are compacted respectively as
Dry of OMC and wet of OMC
Wet of OMC and dry of OMC
) Wet of OMC and wet of OMC
Dry of OMC and dry of OMC where OMC is optimum
1656. A suspended particle falls through a height minutes. If the viscosity of water is and specific gravity of the particle is, the diameter of the particle is (where M is a constant factor)
103M (H/t)
104M (H/t)
105M (H/t)
102M (H/t)
1657. The minimum depth of building foundations on
Sandy soils is 80 cm to 100 cm
Clay soils is 90 cm to 160 cm
Rocky soils is 5 cm to 50 cm
All the above
1658. Terzaghi's analysis assumes:
Soil is homogeneous and isotropic
Elastic zone has straight boundaries inclined at = to the horizontal and plastic zones fully developed
Failure zones do not extend above the horizontal plane through the base of the footing
All the above
1659. The load on a spring per unit deflection, is called --
Stiffness
Proof resilience
Proof stress
Proof load
1660. The ultimate bearing capacity of a soil, is
Total load on the bearing area
Safe load on the bearing area
Load at which soil fails
Load at which soil consolidates