MCQ
1401. Ryall crest voltmeter is used for measurement of--
AC voltage of any form
Low-frequency voltage
High-DC voltage
High-AC voltage
1402. A moving iron instrument can be used for-
DC only
AC only
Both DC and AC
None of the above
1403. In a dynamometer 3-phase power factor meter, the planes of the two moving coils are at----
0°
60°
90°
120°
1404. The operating voltage of a Meggar is about-
6V
12V
40V
100V
1405. The internal resistance of an ammeter should be-
Very small
High
Medium
Infinity
1406. In an energy meter braking torque is produced to--
Safeguard it against creep
Brake the instrument
Bring energy meter to stand still
Maintain steady speed and equal to driving torque
1407. For measurement of inductance having high value, we should use-
Maxwell's bridge
Maxwell Wien bridge
Hay's bridge
Any of the above
1408. In a moving coil instrument, the deflecting torque is proportional to-
Current
Square of the current
Squareroot of the current
Sine of the measurand
1409. Ampere is one of the-
Supplementary units
Derived units
Base units
Units used to measure charge
1410. The disc of an instrument using eddy current damping should be of-
Conducting and magnetic material
Non-conducting and magnetic material
Conducting and nonmagnetic material
None of the above
1411. An instrument transformer is used to extend the range of-
Induction instrument
Electrostatic instrument
Moving coil instrument
Any of the above
1412. An oscilloscope indicates-
Peak to peak value of voltage
DC value of voltage
RMS value
Average value
1413. An ohmmeter is a---
Moving iron instrument
Moving coil instrument
Dynamometer instrument
None of the above
1414. Commonly used instruments in power system measurement are-
Induction
Rectifier
Moving coil or iron
Electrostatic
1415. A dynamometer wattmeter can be used for-
DC only
AC only
Both DC and AC
Any of the above
1416. Direct method is used to measure-
Length
Pressure
Temperature
Voltage
1417. A direct current can be measured by-
AD.C. potentiometer directly
A D.C. potentiometer in conjunction with a standard resistance
A D.C. potentiometer in conjunction with a volt ratio box
None of the above
1418. Most sensitive galvanometer is-
Elastic galvanometer
Vibration galvanometer
Duddlb galvanometer
Spot ballistic galvanometer
1419. Resistances can be measured with the help of-
Watt-meters
Voltmeters
Ammeters
Ohmmeters and resistance bridges
1420. In order to achieve high accuracy, the slide wire of a potentiometer should be-
As long as possible
As short as possible
Neither too small nor too large
Very thick