Image
MCQ
205. Which of the following option is incorrect with respect to angle gauges?
Sine bar is better than angle gauges
Angle gauges are made of high carbon high chromium steel
Angle gauges can measure the angle from 0 to 360 degrees
They are available in two sets of 13 and 16 gauges
210. Which of the following is incorrect for vernier height gauge?
Both the surfaces of measuring jaw should be at 45° to the base
These gauges can be used for scribing purposes
Removable clamps are used
Surface plate is used as datum surface for measurements
214. Which of the following option is incorrect with respect to radius gauges?
Concave radius is an internal radius
Radius gauges are used for final inspection
If the curved surface is external then this radius is known as female radius
Radius gauges are suitable for both fillet and radius measurement
216. Which of the option is correct for given statements about slip gauge form? Statement 1: Grade 2 is the workshop grade. Statement 2: Square slip gauge is more expensive and adhere better to each other when wrong.
Only statement 1 is true
Only statement 2 is true
Both the statements are true
Both the statements are not true
218. Which gauges are present in the first series (degree) of angle ganges?
5°, 10°, 15°, 25° and 40°
1° 3°.9° 27° and 41°
1°.5°.9°.25° and 45°
5°, 10°, 15°, 30° and 45°
219. Which of the option is correct for given statements about slip gauges error? Statement 1: Squareness Error is the amount by which side face deviates from a right angled position with respect to each measuring face. Statement 2: Wringing occurs due to molecular adhesion.
Only statement 1 is true
Only statement 2 is true
Both the statements are true
Both the statements are not true