MCQ
19961. An average length of a pace is-
60cm
80cm
100cm
120cm
19962. A French cross-staff has a magnetic compass at the top.
Right
Wrong
19963. Compensating errors that occur in chaining are proportional to-
L
√L
1/L
1/√L
19964. The angle of intersection of the horizon glass and index glass in an optical square is-
30°
45°
60°
75°
19965. Cumulative errors that occur in chaining are proportional to-
L
√L
1/L
1/√L
19966. A scale which has a common representative fraction, but read in different measures, is called- a
a plain scale
a diagonal scale
a shrunk scale
a comparative scale
ব্যাখ্যা:
19967. The correction to be applied to each 30m chain for a line measured along a slope of 0 is-
30 (1- sine)
30 (1-cose)
30 (1-tane)
30 (1-cote)
ব্যাখ্যা: ঢালজনিত সংশোধনী, C₁ = L (1-cose).
19968. When the length of a chain along a slope of 0 is L, the correction for slope required is-
I sin²θ/2
I cos²θ/2
2I sin²θ/2
2I cos²θ/2
19969. The obstacle, which obstructs vision but not chaining, is a-
river
pond
hill
all of these
19970. The tension, at which the effects of pull and sag for a tape are neutralized, is known as-
initial tension
absolute tension
surface tension
normal tension
ব্যাখ্যা:
19971. The obstacle, which obstructs chaining but not vision, is a-
river
pond
hill
all of these
19972. An open cross-staff is commonly used for setting out-
short offsets
long offsets
oblique offsets
none of these
19973. The area of any irregular figure can be calculated accurately with the help of a planimeter.
True
False
19974. In a direct vernier, the smallest division of a vernier is - the smallest division of its primary scale.
equal to
shorter than
longer than
d none of these
19975. The curvature of the earth is taken into consideration if the limit of survey is-
50 to 100km²
100 to 200km²
200 to 250km²
more than 250km²
ব্যাখ্যা: যে সার্ভে পদ্ধতিতে পৃথিবীর বক্রতা বিবেচনা করা হয়, তাকে জিওডেটিক সার্ভেয়িং বলে। সার্ভে লিমিট 250 বর্গকিমি-এর বেশি হলে জিওডেটিক সার্ভে এবং 250 বর্গকিমি-এর কম হলে
প্লেন টেবিল সার্ভে পদ্ধতিতে জরিপ করা হয়।
19976. A diagonal scale is used to read dimensions.
two
three
four
five
19977. The angle between the reflecting surfaces of a prism square is-
30°
45°
60°
75°
19978. In a prismatic compass, the zero of the graduated ring is located at-
north end
east end
south end
west end
19979. In a whole circle bearing system N25°15′W corresponds to-
115°15′
154°45′
205°15′
334°45′
19980. A line joining the apex of a triangle to some fixed points on the opposite side is called a-
30°
40°
50°
60°