ডিজাইন অব স্ট্রাকচার MCQ
সিভিল ইঞ্জিনিয়ারিং এর ডিজাইন অব স্ট্রাকচার সাবজেক্টের সকল MCQ প্রশ্ন এই ফোল্ডারে পাবেন। Civil Engineering এর চাকরি প্রস্তুতির জন্য ডিপার্টমেন্ট ও নন-ডিপার্টমেন্টের সকল MCQ এর প্রশ্ন উত্তর ব্যাখ্যাসহ এখানে পাবেন। সহকারী/উপ-সহকারী প্রকৌশলী চাকরি প্রস্তুতির জন্য আমাদের App: Engineering Classroom গুগল প্লে-স্টোর থেকে ডাউনলোড করে নিন। Design of Structure all MCQ, Civil Engineering MCQ
161.
In a grillage footing, the maximum shear force occurs at the edge of base plate.
Right
Wrong
162.
Any major beam in a structure is known as a-
subsidiary beam
joist
girder
secondary beam
163.
The width of bearing plate is--- the width of the flange of column.
equal to
greater than
less than
none of these
164.
The unstiffened seated connections are used to transmit end reaction of beam upto-
100kN
150kN
200KN
300kN
165.
In the riveted built-up beams, an allowance of about--- of the area of cover plates is added to the calculated area.
10%
15%
20%
25%
166.
The maximum deflection, for a simply supported beam, should not exceed-
1/125 of span
1/225 of span
1/325 of span
1/425 of span
167.
The maximum allowable stress for rolled steel beams and channels is-
128.5 MPa
181.5 MPa
156.5 MPa
228.5 MPa
168.
A beam that is safe in web crippling will not be safe in web buckling.
Agree
Disagree
169.
Allowable working stress compression in the column splice plate may be taken as-
60 N/mm²
80 N/mm²
100 N/mm²
125 N/mm²
170.
A beam is a structural member subjected to loads.
axial
tansverse
axial and transverse
171.
The main beam is a beam, which supports-
floor construction
joists
secondary beam
none of these
172.
The steel beam of light sections placed in plain cement concrete are called-
joists
simple joists
filler joists
concrete joists
173.
In designing unstiffened seated connections, the length of seating angle is assumed to be ---the width of flange of the beam.
equal to
less than
more than
174.
The shear stress in a beam at neutral axis is-
zero
maximum
minimum
175.
Which of the following is not a tension member?
Cable
Tie
Bar
Boom
176.
Spans of continuous fillers are considered approximately equal when the longest span does not exceed the shortest span by more than---
5%
10%
15%
20%
177.
The allowable bearing stress for rolled
128 N/mm²
156N/mm²
189N/mm²
228 N/mm²
178.
The beams supporting the stair steps are called as-
spandrel beams
trimmers
rafters
stringers
179.
The beams resting on purlins are known as-
spandrel beams
rafters
trimmers
stringers
180.
In a grillage footing, the maximum bending moment occurs at the-
edge of beam
centre of beam
edge of base
plate none of these