MCQ
301. The unit of force in SI system of units is-
Dyne
Kilogram
Newtch
Watt
302. Coefficient of friction is the-
angle between normal reaction and the resultant of normal reaction and the limiting friction
ratio of limiting friction and normal reacion
the friction force acting when the body is just about to move
the friction force acting when the body is in motion
303. A block sliding down an inclined plane has acceleration - acceleration due to gravity.
less than
greater than
same as
none of the above
304. The ratio of limiting friction and normal reaction is known as-
coefficient of friction
angle of friction
angle of repose
sliding friction
305. A heavy ladder resting on floor and against a vertical wall may not be in equilibrium, if-
the floor is smooth, the wall is rough
the floor is rough, the wall is smooth
the floor and wall both are smooth surfaces
the floor and wall both are rough surfaces
306. Angle of friction is the-
angle between normal reaction and the resultant of normal reaction and the limiting friction
ratio of limiting friction and normal reaction
the ratio of minimum friction force to the friction force acting when the body is just about to move
the ratio of minimum friction force to friction force acting when the body is in motion
307. On the ladder resting on the ground and leaning against a smooth vertical wall, the force of friction will be-
downwards at its upper end
upwards at its upper end
perpendicular to the wall at its upper end
zero at its upper end
308. On a ladder resting on smooth ground and leaning against vertical wall, the force of friction will be-
towards the wall at its upper end
away from the wall at its upper end
upwards at its upper end
downwards at its upper end
309. Least force required to draw a body up the inclined. plane is W sin (plane inclination + friction angle) applied in the direction-
along the plane
horizontally
vertically
at an angle equal to the angle of friction to the inclined plane
310. The friction experience by a body, when at rest is known as-
static friction
dynamic friction
limiting friction
coefficient of friction
311. Limiting force of friction is the-
tangent of angle between normal reaction and the resultant of normal reaction and limiting friction
ratio of limiting friction and normal reaction
the friction force acting when the body is just about to move
the friction force acting when the body is in motion
312. The coefficient of friction depends on
area of contact
shape of surfaces
strength of surfaces
nature of surface
313. The friction experienced by a body, when at rest, is known as-
station friction
dynamic friction
limiting friction
coefficient of friction
314. A single force and a couple acting in the same plane upon a rigid body-
balance each other
cannot balance each other
produce moment of a couple
are equivalent
315. Frictional force encountered after commencement of motion is called-
post friction
limiting friction
kinematic friction
dynamic friction
316. The ratio of static friction to dynamic friction Is always-
equal to one
stream line
steady
turbulent
None
317. The angle of inclination of the plane at which the body beings to move down the plane is called-
angle of friction
angle of repose
angle of projection
gone of those
318. If three forces acting in different planes can be represented by a triangle, these will be in-
non-equilibrium
partial equilibrium
full equilibrium
unpredictable
319. Which one of the following statements is not correct-
the tangent of the angle of friction is equal to coefficient of friction
the angle of repose is equal to angle of friction
the tangent of the angle of repose is equal to coefficient of friction
the sine of the angle of repose is equal to coefficient to friction
320. Pick up wrong statement about friction force for dry surfaces. Friction force is-
proportional to normal load between the surfaces
dependent on the materials of contact surface
proportional to velocity of sliding
independent of the area of contact surfaces