MCQ
5481. At what relgon a transistor operates --
Artlive
Saturatioit
Cut off
None
5482. The point of intersection of de and ac load lines is called-
saturation
operating
cut off
none of these
5483. When transistor is used as an amplifier, it is operated in the:
Cut off region
Saturation region
Active region
Both a and b
5484. Class-B power amplifier- miximum collector efficiency কত %
25
78.5
50
60
5485. Emitter follower is used for--
Impedance matching
Current gain
Voltage gain
None of the above
5486. RC coupling is used for---amplification.
voltage
power
current
none
5487. Process of adding impurities to semiconductor is called-
mixing
refining
diffusing
doping
Himalay Sen Sir
ইলেক্ট্রিক্যাল ডিপার্টমেন্ট Mcq
EEE MCQ
Electrical Department all question
বেসিক ইলেক্ট্রনিক্স all mcq
Besic electronics mcq
ব্যাখ্যা: ব্যাখ্যা: The process of adding controlled inpurities to a semiconductor is known as "doping" The amount of impurity, or dopant, added to as intrinsic (pure) semiconductor varies its level of conductivity.
5488. What is the full name of LCD?
Light control diode .
Light crystal display.
Liquid crystal diode.
Liquid crystal display.
5489. Half-wave rectifier- maximum efficiency--%
25
50
40.6
81.2
5490. When there is no forbidden region between the conductance band and valence band, the substance is called:
Semiconductor.
conductor
superconductor
insulator
5491. If, line frequency is 50 Hz, then output (Hz) of a bridge rectifier is-
25
100
50
None
Himalay Sen Sir
ইলেক্ট্রিক্যাল ডিপার্টমেন্ট Mcq
EEE MCQ
Electrical Department all question
বেসিক ইলেক্ট্রনিক্স all mcq
Besic electronics mcq
ব্যাখ্যা: ব্যাখ্যা: Output frequency of bridge rectifier is twice the input frequency. Full wave bridge rectifier, 25,2x50=100H
5492. The most commonly used semiconductor is-
germanium
carbon
sulphur
silicon
5493. Which one is the smallest region in a transistor?
base
collector
emitter
both (a) and (b)
Himalay Sen Sir
ইলেক্ট্রিক্যাল ডিপার্টমেন্ট Mcq
EEE MCQ
Electrical Department all question
বেসিক ইলেক্ট্রনিক্স all mcq
Besic electronics mcq
ব্যাখ্যা: ব্যাখ্যা: The base region of a BJT transistor is very thin and is lightly doped with current carries. It is the region of a transistor which has opposite polarity charge carries from the emitter and the collector regions.
5494. Which causes the barrier layer in a PN Junction--
doping
barrier potential
recombination
ions
5495. If a power supply has no-load and full-load voltages of 30V and 25V respectively, then the percentage voltage regulation is:
10%
20%
15%
25%
5496. In an LC oscillator, the frequency of oscillation is:
Proportional to LC
Proportional to square root of LC
Inversely proportional to the square root of LC
Independent of the value of LC
5497. A PN junction acts as a--
unidirectional switch
bidirectional switch
controlled switch
none of the above
Himalay Sen Sir
ইলেক্ট্রিক্যাল ডিপার্টমেন্ট Mcq
EEE MCQ
Electrical Department all question
বেসিক ইলেক্ট্রনিক্স all mcq
Besic electronics mcq
ব্যাখ্যা: ব্যাখ্যা: The PN junction is conduct with forward bias only. It means they conduct in only one direction (Current flows from P to N) That's why PN Junction acts as unidirectional twitch
5498. The maximum efficiency of a half-wave diode rectifier is --
50%
25%
40.0%
81.2%
5499. Transistor biasing represents --conditions.
ac
both ac & dc
dc
none
5500. For highest power gain, one would use-- configuration.
CE
CB
CC
none of these
Himalay Sen Sir
ইলেক্ট্রিক্যাল ডিপার্টমেন্ট Mcq
EEE MCQ
Electrical Department all question
বেসিক ইলেক্ট্রনিক্স all mcq
Besic electronics mcq
ব্যাখ্যা: ব্যাখ্যা: For highest power gain, CE configuration is used. In CE configuration, biasing capacitor is used to balance the operating point to obtain highest power gain